Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cisco/Tandberg H.323 TelePresence Endpoints

Hello!

Can we safely say:

"for all Cisco/Tandberg endpoints that support H.323 you can establish video calls directly between them without the need for a call control unit like CUCM/VCS"

I have seen that E20 now supports H323. Does this mean we can make direct video calls between 2 E20s or between SX-20 and E20 etc?

Thanks in advance!

1 REPLY
Cisco Employee

Cisco/Tandberg H.323 TelePresence Endpoints

Hi Kelvin,

Yes you can make calls directly using IP address.

Regards,

Sagar

330
Views
0
Helpful
1
Replies
CreatePlease to create content