Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Telepresence C20 upgrade

Hi Guys,

one of our customers have just re-activated the service contract on a C20 video endpoints and he asked us to upgrade it.

I was quite disappointed looking at the actual release software... 2.0! However i haven't seen any upgrade path specified on the release notes... so i just proceeded with the last software version. The upgrade was just fine, the system rebooted and the web interface came back online (was doing this remotely)...but now i'm prompted for a user and a password.. even if there was no password before the upgrade.

I have tried  some "classic" default logins: admin\cisco  admin\TANDBERG admin\CISCO    (also using administrator)... but it always fails.

The only thing i haven't tried yet is a "blank" login ( unfortunately i cannot try it now due to a timezone problem).

Do you have any suggestions?

 

Thanks

 

Dan

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Hi Dan,Try with login = admin

Hi Dan,

Try with login = admin and password = blank

After that if you want to change the password (recommended) clic on admin in the right corner and change password.

Hope it can help.

Regards

Salim

6 REPLIES
New Member

Hi Dan,Try with login = admin

Hi Dan,

Try with login = admin and password = blank

After that if you want to change the password (recommended) clic on admin in the right corner and change password.

Hope it can help.

Regards

Salim

New Member

Hi Salim,thanks for your help

Hi Salim,

thanks for your help, that was my thought as well... unfortunately i will not able to try that until tomorrow.

 

Regards

New Member

Hi Salim,finally i had a

Hi Salim,

finally i had a chance to log on the device, and yes, it was admin and password blank.

However i got one more problem...the codec seems to work fine, we can place and receive calls...but everytime we try to access the system configuration i got a message

 

"Internal server error" : the server could not properly process the request.

 

And then the system reboot.

Have you ever experience a problem like this?

Please consider this system was passing from version 2...to version 7.1.1...i'm fearing some kind of incompatibility, but i have read on the release notes that there is full backward compatibility.

 

 

New Member

Hi Dan,Honestly I never get

Hi Dan,

Honestly I never get this message and symptom.

I  have a C20 with the same release and it work fine.

Is the C20 registered to a GK or do you have a special configuration ?

Maybe you have to open a ticket with the TAC.

They will ask you for xconfig and xstatus files.

 

Best regards

Salim

New Member

I have a C20 with the same

I have a C20 with the same issue right now. It is working fine, but attempting to access the web interface i see only the "internal server error" notification. I'm nervous to leave the unit in production in, as it feels a bit like flying blind, with no ability to monitor call stats or affect the system's configuration. Would love some insight on how to resolve this. My unit is no longer under service, which is rough as the C20 is EOS. Anyone have any ideas? Bueller?

VIP Green

You can try pushing another

You can try pushing another softwre upgrade to it.

Note: while the C20 may be end of sale, if you've previously ahd a service contract on it, you can still renew that service contract up until 1 November 2017, as per the EoS notice.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
257
Views
0
Helpful
6
Replies
CreatePlease login to create content