Cisco Telepresence MCU - Scheduled and ad-hoc conference bridge together
We have CUCM 9.1.1 and MCU 5310 ver 4.4
MCU registered with CUCM as Conference Bridge, Telepresence MCU, and MRG, MRGL. on DX650 and Jabber, we can have conference by pressing conference button. Shall I use same MCU 5310 for scheduled conference?
Like Phones call conference number,enter PIN and join conference ?
Yes. It is possible to configure MCU as CUCM Conference Bridge and same time SIP trunk to same MCU for static conference. Did via CUCM "SIP security profile" Non-security profile with "UDP" and incoming port "5062", then apply this SIP profile to MCU SIP trunk.
Assign this Non-security profile to MCU SIP trunk. and enter MCU IP address and destination port as 5061 of MCU.(on MCU Network>Services, SIP (UDP) is 5061) This way MCU can be used for both "media resource" as well as SIP trunk for static conference.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...