Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco TelePresence MX200

Hey guys.

Recently we've received TelePresence MX200, set it up. it works fine but we are missing 4 screws that keep device itself attached to the stand.

Missing screws is probably our fault due to internal movement , labeling and so on. But I was hoping to get specification for the size of these screws so I can get replacement somewhere around.

p.s. I guess it's unusual issue but that's what we've got.

Best regards, Sergey.

3 REPLIES
VIP Green

Cisco TelePresence MX200

Hi Sergey,

Looking at this document, it appears that the screws you're after would be M6x40mm.

Wayne

--

Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Silver

Cisco TelePresence MX200

Nice Search Wayne

Regards

Ravi kr.

VIP Green

Cisco TelePresence MX200

Thanks Ravi.  Took quite a bit of looking around to find that one   That's the only MX200 documentation I can find that mentions the actual size of the screws - all the others just show where to put them but not the sizes.

Wayne

--

Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
393
Views
0
Helpful
3
Replies
CreatePlease to create content