I was awaiting for the CEC on/stand by possibilities of the TC4.2.1 software for a while only to find out that it does not work with LG CEC (aka SimpLink), but on the other hand it works fine with Sony's BRAVIA Sync.
We have also tested with LG SimpLink and it is sending vendor specific commands and will not reply to stand-by requests. This limitation will be added to the release notes.
We have also tested with LG SimpLink and it is sending vendor specific commands and will not reply to stand-by requests. This limitation will be added to the release notes.
It was a little bit misleading, given the fact that the same release notes say, that LG SimpLink is supported, but it is actually not in the real world. It would be probably much nicer to correct this issue and of course correct the release notes in short term.
This, of course, does not only apply to the C20, but C series in general - I'm told Cisco is raising this issue with LG.
Please rate replies and mark question(s) as "answered" if applicable.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
