Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco VC's

How do I force monitor outputs by using TRC remote on Cisco unit?

  • TelePresence
Everyone's tags (3)
1 REPLY
Cisco Employee

Cisco VC's

Hi Le Roux Joubert

When not in a call, press the sequence:

"disconnect - * - # - * - # - 0 - x - #"

Where x is output 1 to 4 to change the OSD and restore the resolution (1280x720@60Hz for HDMI and 1024x768@60Hz for DVI) to the selected output.

Was this what you were looking for?

/Magnus

330
Views
0
Helpful
1
Replies
This widget could not be displayed.