Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Codec C40 - Remote Control / Touch Controller [Either One]

Hi all TP Experts,

I just bought a C40 and just set up that. I have the "Remote Control" and the "Touch Controller", that are set up normally and can

uniquely operate.

But that cannot operate together, that mean I connected the "Remote Controller", then the "Touch Controller" cannot use and I connected the "Touch Controller", then the "Remote Controller" cannot use.

Is it I only can use the either one control?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Codec C40 - Remote Control / Touch Controller [Either One]

Hi CHi Fai,

yes, you can use only one device at the time.

Best regards, Ahmad

4 REPLIES
Bronze

Codec C40 - Remote Control / Touch Controller [Either One]

Hi CHi Fai,

yes, you can use only one device at the time.

Best regards, Ahmad

New Member

Codec C40 - Remote Control / Touch Controller [Either One]

Thanks for your reply!

Is it possible to set use that together?

New Member

Codec C40 - Remote Control / Touch Controller [Either One]

Hi Chi Fai,

This is not possible...

Bronze

Codec C40 - Remote Control / Touch Controller [Either One]

Hi Chi Fai,

I was away for a while but I see Ashwani already provided with the answer and I just want to reiterate his answer, only one device at the time.

best regards, Ahmad

236
Views
0
Helpful
4
Replies