Codian bridge misinterpreting FECC cammands from EX90
I have a Codian bridge running software version 4.4(3.57) . Connected to the bridge is an EX90 running software version TC7.2.1.cb31c3d. When the EX90 tries to control a far end point camera through the bridge using FECC commands, it works for a while and then the bridge starts interpreting the FECC commands as layout commands and puts the EX90 in self view mode. Is this a know problem and is there a fix for it?
This sounds like expected behavior to me. My guess is that the Bridge is configured to allow for layout control using FECC and it is also setup to pass FECC for camera control. These settings can both operate at the same time. To read how this works see this guide on page 49 http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/mcu/admin_guide/Cisco_TelePresence_MCU_4-4_Product_administration_guide.pdf
Specifically it states that "When one control mechanism can control either the layout or the far end camera, then that mechanism will always control the layout until "Zoom in" (FECC mechanism) or '1' (DTMF mechanism) is pressed. The control mechanism then switches over to control the camera"
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...