Configuration Template not working on the MXP Endpoints from TMS
We have a TMS with Version 14.3.1 and also many MXP and C series Endpoints.We had created the configuration template on TMS for making the Far end control off on every end point.We had created the template in TMS with the following option selected from the " select advanced settings " ie Conference Farend Control Mode in all systems.When we set this on the systems of C series and MXP series found that the template is working fine with the C Series Endpoint endpoint but not even working on the MXP endpoints.We restarted the system and again created the configuration template only for MXP endpoint with Conference Farend control Mode,Key far end and Far end camera Control and found not working on the system.
Our all MXP endpoints are on versions F9.3.1.Please suggests on this
what selected part needs to be selected in template for far end so that it may work on the MXP endpoints.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.