I have a c40 and cannot get the second camera to control via the daisy chain. I have tried several cable connetions but cannot get the camera to work. I looked at the xstatus and camera 2 always comes back as false. I have swapped the camera positions and still get the same result I can control the camera in position one, but not in postion 2.
Hi Few things to be kept in mind 1) if using cisco 12x and 4x camera then 4x will always be the last camera in daisy chain. First camera will be 12x camera 2) Ideally use cisco provided daisy chain cable if not sure about your custom made cable.
3) if this is a third party camera check for the compatibility first.
Once we receive more inputs from you probably picture will be more clear...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...