Has anyone had any luck controlling an SX20 via IP/telnet with a Crestron control system? Is this possible? I've seen posts elsewhere saying that it's possible, but I'm not able to make it work. I can send commands to the unit over telnet with Putty, but the unit won't accept commands through my control system via telnet. I have telnet turned on in the codec - is there anything else (settings, configurations, etc) that I have to do in the codec to make this work?
Hello - were you able to control the SX20 via Crestron? If so, what was the issue?
Our programmers have told me that the issue they ran into was that Crestron requires a telnet password, but the SX20 did not provide one. Looking at the admin guide, it appears that you can enable a root user password. I am wondering if this would help with the Crestron communication.
We are about to deplay another SX20 with a Crestron DMPS-300 and am hoping to have a solution before hand.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.