Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Copy configurations between like telepresence systems

Is it possible, using TMS, or other method, to copy configurations from one system to another?  I have 10 new SX20s to deploy that I would like to be set up exactly the same (different H323 info, of course).  Can Persistent settings be used to copy a config to create a template?

Darren

6 REPLIES
VIP Green

I usually configure one, then

I usually configure one, then log in to the CLI and take a dump of the xconfig. Edit the required details and paste it back in to a CLI session on each of the new ones. Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Yes, this is how I do things

Yes, this is how I do things too.

I asked this very question several years back and I can't quite believe there is no simple way to do this in TMS (as far as I know) which is where you would have thought that such an operation would take place.

 

Cheers

Chris

 

VIP Purple

Have you considered using

Have you considered using configuration templates?  It would require you to setup one template yes, but once done, it's just a matter of pushing it out via TMS.  Good thing is that you can edit or update the template and push it out over and over to configure endpoints as you need.  Quicker than logging into CLI of each endpoint.

New Member

Patrick, you're right, I

Patrick, you're right, I could build a template.  I was just asking why there isn't an easier way.  You would think by now I could build a template from an existing system.

 

VIP Purple

That would be nice, like the

That would be nice, like the ability to take the configuration xml file from the codec and upload it to TMS to generate a template from it.

I asked that question a few

I asked that question a few years ago as well. Looks like no one is listening.......

30
Views
0
Helpful
6
Replies