I have a client who has just implemented a pair of CS40s integrated with CUCM 8.6 over H.323. All is working fine internally, and the two units can call each other with both voice and video.
We also have a 2951 ISR equipped VWIC3-1MFT-T1/E1 which is attached to ISDN PRI which is currently routing voice calls external to the organisation.
Question is - can the CS40 route video calls out to external PSTN parties equipped with video endpoints using this gateway? We already have an old Polycom VC unit attached to the same ISR over ISDN BRIs (ISR is configured network side on the BRI ports) which works fine. Only difference with the CS40 is that it will be routing the calls into the ISR over H.323 (we could convert to SIP if required).
Searching on google throws up as separate ISDN GW (the 3241), however I don't really want to go down this route as it means additional hardware, and additional ISDN PRI interfaces.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...