Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CTS 3010 - LCD not detected by System

System shows LCD is not detected via serial. Serial cable connection is according to procedure. What else can I miss ?

  • TelePresence
Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: CTS 3010 - LCD not detected by System

Hi,

Just to be sure, did you activate LCD in CUCM?

What is the version of your CUCM?

Regards,
Samuel

5 REPLIES
New Member

Re: CTS 3010 - LCD not detected by System

Hi,

Just to be sure, did you activate LCD in CUCM?

What is the version of your CUCM?

Regards,
Samuel

New Member

Re: CTS 3010 - LCD not detected by System

Why CUCM ? But LCD is connected direct to ACU & indirect t

o Primary Codec.

New Member

Re: CTS 3010 - LCD not detected by System

Yes but you need to activate LCD in the CUCM in the CTS-3010 device that you create.

New Member

Re: CTS 3010 - LCD not detected by System

OK. I will check with person in charge as I dont't have CUCM access.

What about CTSAdmin ? Any activation/ configuration ?

New Member

Re: CTS 3010 - LCD not detected by System

kllow5115 a écrit:

What about CTSAdmin ? Any activation/ configuration ?

No

934
Views
0
Helpful
5
Replies