03-23-2014 11:40 PM - edited 03-18-2019 02:46 AM
Hi Team
can we used the CTS-CTRL-DV10= at cisco end point SX20 or C series ?
Thanks
Yusuf
03-24-2014 01:39 AM
Hi
No. CTS-CTRL-DV10 is only for MX300G2
br Oleksandr
07-29-2014 01:11 AM
Touch 10 will support SX10 and SX20 with TC7.2 software.
TC7.2.0 is in beta 4 as of this moment. FCS has been pushed back to August.
03-27-2015 01:43 PM
Hi all,
Sergey is correct when he says that the touch 10 is supported on SX series (including SX20 on TC 7.2 or higher). The touch 10 (CTS-CTRL-DV10) will also work for all G2 devices such as the MX300G2, MX200G2, MX700, MX800, and even the IX5000.
07-22-2015 09:49 AM
Yes it should. Unless I am mistaken the 8 and the 10 now run the same firmware.
I use it on almost all of these devices, I wish it worked on the CTS devices though - I HATE the 7945 on it...
This is from the Cisco Website:
Touch 8-inch devices support the Cisco TelePresence EX Series (EX60, EX90), Cisco TelePresence Profile Series (Profile 42, Profile 55, Profile 65), Cisco TelePresence MX Series (MX200 and MX300), Cisco TelePresence Integrator C Series (Integrator C40, C60, C90), and the Cisco TelePresence SX20 Quick Set.
● Touch 10-inch devices support the second-generation MX300 and future generations of SX and MX Series.
● Touch 12-inch devices support Cisco TelePresence TX Series (TX9000, TX9200 and TX1310), Cisco TelePresence System 3000 Series (3010), Cisco TelePresence System 3200 Series (3210), Cisco TelePresence System 1300 Series (1300-47, 1300-65), Cisco TelePresence System 1100 (1100), and Cisco TelePresence System 500-32 endpoints.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide