Cisco Support Community
Community Member


Hi Team

can we used the CTS-CTRL-DV10=  at cisco end point SX20 or C series ?






HiNo. CTS-CTRL-DV10 is only


No. CTS-CTRL-DV10 is only for  MX300G2

br Oleksandr

br Oleksandr
Cisco Employee

Touch 10 will support SX10

Touch 10 will support SX10 and SX20 with TC7.2 software.

TC7.2.0 is in beta 4 as of this moment. FCS has been pushed back to August.

Cisco Employee

Hi all,Sergey is correct when

Hi all,

Sergey is correct when he says that the touch 10 is supported on SX series (including SX20 on TC 7.2 or higher). The touch 10 (CTS-CTRL-DV10) will also work for all G2 devices such as the MX300G2, MX200G2, MX700, MX800, and even the IX5000.

Community Member

Yes it should. Unless I am

Yes it should. Unless I am mistaken the 8 and the 10 now run the same firmware.


I use it on almost all of these devices, I wish it worked on the CTS devices though - I HATE the 7945 on it...


This is from the Cisco Website:


Touch 8-inch devices support the Cisco TelePresence EX Series (EX60, EX90), Cisco TelePresence Profile Series (Profile 42, Profile 55, Profile 65), Cisco TelePresence MX Series (MX200 and MX300), Cisco TelePresence Integrator C Series (Integrator C40, C60, C90), and the Cisco TelePresence SX20 Quick Set.

   Touch 10-inch devices support the second-generation MX300 and future generations of SX and MX Series.

   Touch 12-inch devices support Cisco TelePresence TX Series (TX9000, TX9200 and TX1310), Cisco TelePresence System 3000 Series (3010), Cisco TelePresence System 3200 Series (3210), Cisco TelePresence System 1300 Series (1300-47, 1300-65), Cisco TelePresence System 1100 (1100), and Cisco TelePresence System 500-32 endpoints.

CreatePlease to create content