Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CTS Manager & Multipoint connectivity with CA Spectrum Management Software through SNMP v2

I am configuring CTS Manager & Multipoint to interface with CA Spectrum management software through SNMP v2, the administrator of the CA Spectrun Software is asking for the MIBs & OID. From where I can get the MIBs & OIDs and which MIBs & OIDs I should send to CA Spectrum Management software administrator to work it properly with CTS Manager & Multipoint. CTS Manager & Multipoint are running software ver 1.6.

3 REPLIES
Cisco Employee

Re: CTS Manager & Multipoint connectivity with CA Spectrum Manag

MIB information for the CTM and CTMS products can be found at the following locations:

CTS Manager:

http://www.cisco.com/en/US/partner/docs/telepresence/cts_manager/1_6/admin/ctm1_6adminguide.html

Chapter: Supported MIBs for Cisco TelePresence Manager

CTMS:

http://www.cisco.com/en/US/partner/docs/telepresence/multipoint_switch/1_6/admin/CTMS_Release1_6.html

Chapter: Configuring CTMS Administration Software.

Half Way down the document below table 4-6 on SNMP Settings, It lists the FTP server where MIB support is listed.

Let us know if this does not provide what you need.

Thanks,

Wayne D.

New Member

Re: CTS Manager & Multipoint connectivity with CA Spectrum Manag

And what are MIBs & OIDs required for CTS 3000 System.

Green

Re: CTS Manager & Multipoint connectivity with CA Spectrum Manag

ftp://ftp-sj.cisco.com/pub/mibs/supportlists/cts/cts-supportlist.html

For OID you can use any snmp translator once you install the MIB

725
Views
0
Helpful
3
Replies
CreatePlease to create content