Cisco Support Community
Community Member

CTS-PHD1080P12XS2 is support on SX80 codec



the CTS-PHD1080P12XS2  PrecisionHD Camera 1080p12x  is supported on SX80 codec.


i've one sx80 witch speaker track and think buy a 3th camera CTS-PHD1080P12XS2 but no found document to support this camera on SX80.




Everyone's tags (2)
VIP Super Bronze

According to the SX80 Data

According to the SX80 Data Sheet, it only supports the following codec/camera combinations:

  • SX80 Codec and PrecisionHD 1080p 4x camera for smaller room scenarios
  • SX80 Codec and Precision 60 Camera, for lager room scenarios with the best image quality in the market
  • SX80 and the SpeakerTrack 60 dual camera system, which features a unique direct, fast switching approach for active speaker tracking

You can take a look at the SX80 Installation Sheet, to see how you can use the above cameras.

Community Member

There's a DB9 for serial

There's a DB9 for serial control of cameras.  PHD1080p12x and PHD720p both worked for when I tried with the SX80

Use the same pin-out for camera cable as you would for a C60, will need separate power supply for the camera though, as there's no DC power from the SX80 camera serial port. 

Was also able to daisy chain camera control (same method as for C60, using RJ11 to RJ45).

Cisco Employee

Re: CTS-PHD1080P12XS2 is support on SX80 codec

VIP Purple

Re: CTS-PHD1080P12XS2 is support on SX80 codec

The CE9 Relsase notes (Page 9) says that the 1080p 12x camera is only partly supported on an SX80.  Basic PTZ is supported.  Software updates are not supported, and daisy chaining, while it may work, is not supported.

Please remember to rate responses and to mark your question as answered if appropriate.
CreatePlease to create content