04-03-2012 02:57 AM - edited 03-17-2019 11:00 PM
Hi all,
In CUCM serviceabilty>Tools>Featured Services, i found the page was blank. (attached)
is it normal ? because when i read the manual of CUCM 8.6, for adding the Tandberg Endpoint TC5 to CUCM, there is need to activate in that page.
please help
04-03-2012 03:35 AM
Hi kabiru,
This is not normal, If you can't access it.
There is some problem with your CUCM. What about network services under control center??is that accessible.??
you can try to restart apache service by going into network services.
And lastly i think you would like to post this question in the CUCM forum so that you get more responses there.
Thanks
Alok
04-03-2012 04:13 PM
Actually, yes it is normal. You need to select which Callmanager server you want from the drop down list (Where you have CUCMALAINSI listed now) and press "Go".
Feature services are controlled on a per-server basis rather than for the entire cluster, hence the need to select which server you want to activate services on.
04-04-2012 09:33 PM
Hi sorry because i still newbie in cucm, may i ask how to reinstall the CUCM in MCS-server, or you can provide the link i can learn.
i usually use VMware so when i have problem just blow it up and make new one ;-)
please help me
04-04-2012 11:18 PM
Hi kabiru,
There are lot of stuff out on internet regarding CUCM. if you type in the google you will get "n" number of hits.
although check this links
http://www.computerfreetips.com/Cisco-Call-Manager-CUCM/Cisco-CUCM8-install-vmware.html
check the below as well..
http://www.youtube.com/watch?v=K5fu7i1mfBE
its video on youtube.
Thanks for the feedback. Please rate the message by clicking on the stars given below of the message.
Thanks
Alok
04-04-2012 11:30 PM
Hi Alok,
thanks for your help
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide