Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCM with Video

Good morning,

we have here a CUCM (9.1.2.10000-28) installed, upgraded from older version. It is located in an laboratory.

Registered Endpoints are :

- C20

- E20

- Jabber Clients

- SIP TRUNK to VCS

I can do only voice call between all of these clients.

I have checked the regions (BW:256kb) and locations (unlimited).

Everything look fine, but no video.

I have done a second fresh installation, there everything works fine.

I'm totally confused, where the problem can be.

I hope someone can help me.

Everyone's tags (5)
7 REPLIES

Re: CUCM with Video

Have you configured your environment according to this document?

http://www.cisco.com/en/US/docs/telepresence/endpoint/codec-c-series/tc6/administration_guide/administering_endpoints_running_tc6_on_ucm911.pdf

Can you double check?

Paulo Souza

Was my response helpful? Please rate useful replies and remember to mark any solved questions as "answered".

Paulo Souza Was my response helpful? Please rate useful replies and remember to mark any solved questions as "answered".
Cisco Employee

Re: CUCM with Video

Hi Jens,

The bandwidth specified is for the whole call, so if you run 256kb AAC sound you have no bandwidth left for video.

Raise the bandwidth to 2mbps to get 720p or 6mbps to get 1080p

//Marius

New Member

Re: CUCM with Video

Hi,

yes i have configured regarding to the guide.

My informations about the Regions was not complete.

Regions max Audio: 256kb

Regions max Video: 6144kb

All locations are set to UNLIMITED.

To me it look like the videofeature is complete disabled at the CUCM.

Is this possible???

// Jens

Re: CUCM with Video

What about the license in your CUCM? Do you have license for Single Screen Telepresence applied? This is required for Cisco/Tandberg endpoints.

Paulo Souza

Was my response helpful? Please rate useful replies and remember to mark any solved questions as "answered".

Paulo Souza Was my response helpful? Please rate useful replies and remember to mark any solved questions as "answered".

CUCM with Video

Hi Jens

Which device uses the VCS?

E20 on CUCM don't need Single Screen TelePresence license.


br Oleksandr

br Oleksandr
New Member

Re: CUCM with Video

Hi everybody,

we have the official test license key installed on that system.

License Usage Report shows that 1 Telepresence Room is in use.

The main thing is we will get the jabber with video working. The C20 and the e20 are just for testing the jabber video.

Normally they are registered on the vcs system. On the vcs system are all room systems and several older MOVI Clients.

But no video call can be done with the CUCM.

New Member

CUCM with Video

Hi,

What was the resolution to this issue?

Regards,

Amir

593
Views
0
Helpful
7
Replies
CreatePlease login to create content