Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Default presentation pc on codec c60

Dear All,

 

i already install codec c60. when i try to share a presentation, i should use the remote and select presentation > pc.

because the default is no presentation. can i change the presentation to pc as default?

 

Thx,

Anju

1 REPLY

Yes, you can. Suggest you see

Yes, you can. Suggest you see the admin guide, page 108: http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/codec-c-series/tc7/administration-guide/profile-c60-c40-and-codec-c60-c40-administrator-guide-tc70.pdf

A quick press of the presentation key on the remote control will bring up the default presentation source, holding it down will give you the option to choose from different presentation sources.

Also see page 110 for further options re VideoInputSource; PresentationSelection.

You can set all of the above either through the codecs web interface, or using CLI.

/jens

Please rate replies and mark question(s) as "answered" if applicable.

 

Please rate replies and mark question(s) as "answered" if applicable.
57
Views
0
Helpful
1
Replies
CreatePlease to create content