Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dial format from tandberg C20 to Polycom

Hi,

I have a question about the dial format to call from a Cisco/Tandberg C20 to a Polycom H323 device.

I tryied to call using the following formats:

Public_IP##extention

extention##Public_IP

Public_IP!extention

Public_IP@extention

The didn't work at any time. I'm not sure if the format is correct.

Thanks,

2 REPLIES
Cisco Employee

Re: Dial format from tandberg C20 to Polycom

Hi

Did you try setting the C20 call setup mode to direct and only call the public ip of the polycom unit?

/Magnus

Sent from Cisco Technical Support iPhone App

Re: Dial format from tandberg C20 to Polycom

In addition to Magnus' comment; if your C-system has an earlier firmware version than TC4.2, then it cannot do URI dialling unless it's registered to a GK, VCS etc as h.323cs was not supported in earlier software releases.

Also note the PLCM system has to be registered to a GK or similar to be able to receive URI type of calls.

Older PLCM systems also does not support Annex O URI dialling, which is the standard, and this is the only type of URI dialling which is supported by C-series.

Annex O: Alias@domain or you can also use Alias@GK_IP_address.

IP_address##Alias is PLCM proprietary "URI dialling" and will not work from a C-series.

You can, if you're using a VCS-C/VCS-E set-up, allow PLCM systems to call you using IP_address##Alias by doing a presearch transform on the VCS-E which transforms this address to Annex O type address.

/jens

Please rate replies and mark question(s) as "answered" if applicable.
2081
Views
0
Helpful
2
Replies