I have a customer that had sever C60 profile 52 dual display systems. These endpoints had the multi-site option key.
I recently put in an MCU 4501 for them and enabled multiway.
With the dual display systems using jsut multi-site, when room A called rooms B and C, each was displayed on it's own display. Now that the MCU is used when ever they add the third room, it push the image only to one display. I can change the display format using the templates in the MCU, but that does not get the image to both displays.
Is there a way to have the same display behaviour they had with Multisite using the MCU? Meaning if there are only three rooms in the conference, then each room is displayed on it's own display.
Agreed. The disparity between MultiWay and MultiSite provides a very challenging experience for an unsavvy end user as well as make support difficult as well. We are only using MultiWay for scheduled conferences with a large number of participants, for Movi users, and for E20's. All other endpoints are using their inherent MultiSite option.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...