Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

E20 issue - in P-T-P mode encryption works only without VCS

I have two E20 ip-phones with ‘best effort’ encryption settings. Software - TE4.0.0.246968. When I didn’t set the VCS address in the menu, a p-t-p call has the encryption. Only I set any TMS settings (real or fake), the p-t-p call becomes non-encrypted.  Did anybody had this problem?

Everyone's tags (3)
2 REPLIES
Cisco Employee

E20 issue - in P-T-P mode encryption works only without VCS

Hi Amayak - Good morning.  Could you verify this call is local to VCS?  Also, when you register to VCS, can you force both to Auto or TLS for connection method and re-verify through VCS? 

VR

Patrick

Cisco Employee

E20 issue - in P-T-P mode encryption works only without VCS

Hi,

I am using VCS x7.0.2, E20 TE4.0 and in a point to point call when registered to VCS, is still an encrypted call.

regards,

517
Views
0
Helpful
2
Replies
CreatePlease to create content