Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

EX Series - Facility Service

Perhaps I can't see the wood through the trees. If you configure more than one facility service how do the end users access these? The first facility service for example is the helpdesk which is displayed on the touch controller but how are the remaining ones accessed?

Thanks in advance.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

EX Series - Facility Service

Hi,

The other 4 are there more for system integrator used.  If you are using 3rd party external controller, you can use the commands and integrate to your own touch panel. But this is more applicable if you use intergrator's codec.

Regards,

2 REPLIES
VIP Purple

EX Series - Facility Service

According to the Admin Guide, "Only FacilityService Service 1 is available on the Touch controller, and its Name is used on the facility service call buttion.  Facility services are not available when using the remote conrol and on-screen menu".

If only one is available, then it does raise the question as to why it allows you to configure 5 of them?

Wayne

--

Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Cisco Employee

EX Series - Facility Service

Hi,

The other 4 are there more for system integrator used.  If you are using 3rd party external controller, you can use the commands and integrate to your own touch panel. But this is more applicable if you use intergrator's codec.

Regards,

364
Views
14
Helpful
2
Replies
СоздатьДля создания публикации, пожалуйста в систему