In the process of replacing our old 1000MXP endpoints with new EX60 units. Trying to lock things down real tight for security purposes. Set a password to prevent user access to the admin settings through the touch panel. Is it possible to drill down further and prevent the network config info from being viewed on the touch panel, similar to how it can be done on the MXP series with the OSD PasswordViewAdminSettings option? Also, I would like the either the system name, H323 ID, E164 alias or to be displayed on the top center of the touch panel and the top left of the endpoint monitor. Currently the IP address of the endpoint is displaying.
Thanks for the info. Which API reference guide is your source? I could not locate one specifically for the EX series.
Changing the xConfiguration SystemUnit ContactInfo Type from Auto to E164Alias was what I was after. Would have the IA folks breathing easier if the generic system info page on the touch screen could be locked out.
Thanks for the response. I already have access to the admin settings password protected. I need display of those settings via the system information page on the touch panel to also be password protected. There is nothing stopping anyone with physical access to the touch panel from viewing the system information.
Also, even though I had previously registered the endpoints to my VCS the IP addresses continued to display on the monitor and the touch screen. Following Martin's suggestion above is how I was able to remedy that aspect of the situation.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...