Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EX90 booting problem

Hi,

The EX90 is not booting up. So I can not reach it. Is it possible to do factory reset with any button or something on EX90?

Best regards,

5 REPLIES
New Member

EX90 booting problem

Hello Tufan,

I'm not sure which TC release you run during this time. Example :  TC5.1

http://www.cisco.com/en/US/docs/telepresence/endpoint/software/tc5/release_notes/tc_software_release_notes_tc5.pdf

In TC5.1 the following method will be used to factory defaulting the systems:

EX90

• When the unit is off, press and hold the power button

• Wait until the power LED goes dark and then light up again (approximately 10 seconds).

• Then release the power button and press it twice.

• The system will boot up and display a confirmation message on the video screen if the

process was successful.

If you run othe release, please check out the release notes on CCO.

/Hans

New Member

EX90 booting problem

Thanks Hans for the answer. I restored the EX90 to factory defaults but still I having the same problem. It doesn't boot up correctly.

Cisco Employee

Re: EX90 booting problem

How "far" does the unit boot? There's a document posted here which describes the booting process by looking at indications on the screen and or touch panel. Could you please check the document and explain what you see when booting ?  Do you have any IP connectivity to the device?

** document link removed - not publicly available**

New Member

EX90 booting problem

Hi Danny,

I can not find the document. Could you please add it again.

Regards,

Cisco Employee

EX90 booting problem

Hello,

the moderator of this forum pointed out me the link I provided was internally to Cisco. I am in contact with the moderator to check how I can post the data on this public forum. Stay tuned.

1062
Views
5
Helpful
5
Replies
CreatePlease login to create content