Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Freezing- Presentation SX20 to MXP Endpoints

We have an issue where an SX20 codec in presenter mode showing a slide Presentation freezes as the slides are advanced on 7 1700 MXP endpoints.  The other endpoints do not see the presentation advancing.  it just freezes on their end.  The devices are registered to a VCS control server and we have an older legacy MCU, MPS200.  Could the MPS200 possibly be the bottleneck?

We have a new Cisco 5300 MCU that we are converting to.  I would appreciate any advice or thoughts related to this.

Sent from Cisco Technical Support iPhone App

Sent from Cisco Technical Support iPhone App

1 ACCEPTED SOLUTION

Accepted Solutions

Freezing- Presentation SX20 to MXP Endpoints

Sure, the MPS can be an issue. If you have the 53xx as well, try it there.

The MPS is a really old style of MCU and there can always be always interop issues.

Please remember to rate helpful responses and identify

4 REPLIES
Silver

Re:Freezing- Presentation SX20 to MXP Endpoints

Hi

Do you have multisite option on sx20 if yes if you make a multisite call among three 1700 mxp do you still see the issue happening.
Also if you have multisite on any mxp try the same among them direct call.

Are all the devices on same network?
Does this only occur when presentation is shared from sx20 or vice versa.

Regards
Ravi kr.

Sent from Cisco Technical Support Android App

New Member

Freezing- Presentation SX20 to MXP Endpoints

We are using an MCU.  None of these units have the multi site option.

Freezing- Presentation SX20 to MXP Endpoints

Sure, the MPS can be an issue. If you have the 53xx as well, try it there.

The MPS is a really old style of MCU and there can always be always interop issues.

Please remember to rate helpful responses and identify

New Member

Freezing- Presentation SX20 to MXP Endpoints

The older bridge was the issue.  The 5300 appeared to resolve the problem.

287
Views
0
Helpful
4
Replies
CreatePlease login to create content