I have configured a VCS X7.2 with SX20 and polycom endpoints, both of them are registered to VCS. My aim is make/receive internal calls with other endpoints which are registered with a gatekeeper polycom, how can i do that? may be, via neighbor zone?
You can easily neighbour them if neither are behind a firewall and there's no NAT involved. If there' firewalls and/or NAT'ing involved then you really need to throw a VCS-E into the mix. Howevet, if the Polycom side has been configured correctly, then you should be able to call these systems using URI dialling; i.e alias@domain or alias@ip_address.
Please rate replies and mark question(s) "answered" if applicable.
Please rate replies and mark question(s) as "answered" if applicable.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4