GW 3610

[juan_cye_ccna]

Hi,

I am going to configure a AM GW 3610 but in Lync 2010 infraestructure there is not a "director" server, config. manual says that OCS/lync signaling destination address field should be a director server, which lync server should I configure with?

Thanks in advance.

[Martin Koch · Accepted solution]

Please always mention the version numbers of the used components as well as some more info about the deployment.

In general check out the documentation first:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Microsoft_Lync_2010_Deployment_Guide_X7-2.pdf

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Microsoft_Lync_and_Cisco_AM_GW_Deployment_Guide_X7-2.pdf

If you check out the lync2010 deployment guide on page 35:

So if you do not have a director(pool) and only have the FEP (front end server / processor), you point it to the FEP.

Please remember to rate helpful responses and identify helpful or correct answers.

[juan_cye_ccna]

Hi Martin, thanks for your prompt assistance this info was pretty useful.

[Martin Koch]

Juan!

Thank you for setting it to answered and giving a feedback!

This is important for this forum as well. So +5 for you!

Good success with your deployment!

Please remember to rate helpful responses and identify helpful or correct answers.