Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

GW 3610

Hi,

I am going to configure a AM GW 3610 but in Lync 2010 infraestructure there is not a "director" server, config. manual says that OCS/lync signaling destination address field should be a director server, which lync server should I configure with?

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: GW 3610

Please always mention the version numbers of the used components as well as some more info about the deployment.

In general check out the documentation first:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Microsoft_Lync_2010_Deployment_Guide_X7-2.pdf

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Microsoft_Lync_and_Cisco_AM_GW_Deployment_Guide_X7-2.pdf

If you check out the lync2010 deployment guide on page 35:

So if you do not have a director(pool) and only have the FEP (front end server / processor), you point it to the FEP.

Please remember to rate helpful responses and identify helpful or correct answers.

Please remember to rate helpful responses and identify

3 REPLIES

Re: GW 3610

Please always mention the version numbers of the used components as well as some more info about the deployment.

In general check out the documentation first:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Microsoft_Lync_2010_Deployment_Guide_X7-2.pdf

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Microsoft_Lync_and_Cisco_AM_GW_Deployment_Guide_X7-2.pdf

If you check out the lync2010 deployment guide on page 35:

So if you do not have a director(pool) and only have the FEP (front end server / processor), you point it to the FEP.

Please remember to rate helpful responses and identify helpful or correct answers.

Please remember to rate helpful responses and identify

Community Member

GW 3610

Hi Martin, thanks for your prompt assistance this info was pretty useful.

Re: GW 3610

Juan!

Thank you for setting it to answered and giving a feedback!

This is important for this forum as well. So +5 for you!

Good success with your deployment!

Please remember to rate helpful responses and identify helpful or correct answers.

Please remember to rate helpful responses and identify

285
Views
0
Helpful
3
Replies
CreatePlease to create content