Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

How to configure a firewall for a SX20 registered on a VCS Expressway

Hi all,

As you can see in the picture, I have a classic situation. Everything is working properly.

Technip Issue.jpg

Now customer needs to use a cisco SX20 in a branch office.

The Cisco ASA 5540 firewall is currently configured as follows:

  1. static (inside, outside) 213.42.140.136 (public ip) 10209252166 (internal ip)
  2. access-list extended permit ip host 87.241.12.76 OUTSIDE_access_in (VCS Expressway IP) host 213.42.140.136

I have done many tests:

  • SX20 H.323 configuration whit Nat On, Off and Auto

In all cases the system is recorded correctly, but the call signaling does not occur.

  • If instead of using my own system with a public IP it works fine.

Can anyone help me how to properly configure the firewall?

thanks in advance

  • TelePresence
1 ACCEPTED SOLUTION

Accepted Solutions

How to configure a firewall for a SX20 registered on a VCS Expre

Check on the asa that threre is no fixup / inspection enabeld for sip, h323 and skinny.

You find a doc regards voip and ASA here:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008081042c.shtml

Please remember to rate helpful responses and identify

6 REPLIES
New Member

Re: How to configure a firewall for a SX20 registered on a VCS E

What does the ASDM on the firewall say in terms of logging of blocked traffic when it doesn't work?

Sent from Cisco Technical Support iPhone App

New Member

Re: How to configure a firewall for a SX20 registered on a VCS E

What does the ASDM on the firewall say in terms of logging of blocked traffic when it doesn't work?

Sent from Cisco Technical Support iPhone App

How to configure a firewall for a SX20 registered on a VCS Expre

The firewall manager, says that there are no packets dropped.

thanks for the quick response

How to configure a firewall for a SX20 registered on a VCS Expre

Check on the asa that threre is no fixup / inspection enabeld for sip, h323 and skinny.

You find a doc regards voip and ASA here:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008081042c.shtml

Please remember to rate helpful responses and identify

New Member

Re: How to configure a firewall for a SX20 registered on a VCS E

What log level are you looking at?

Does it show the packets getting through?

Sent from Cisco Technical Support iPhone App

How to configure a firewall for a SX20 registered on a VCS Expre

Thanks Martin

Following the guide  that you suggested I configured the firewall and now everything is working properly.

Best Regards

1446
Views
0
Helpful
6
Replies
This widget could not be displayed.