Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to factory reset C40

Hi Cisco,

How to factory reset C40?

The problem is that someone accidentally disabled the infrared between the codec and the remote control.

How to re enable back the infrared so that we can access the C40 menu options again?

Thanks

Everyone's tags (4)
5 REPLIES
Cisco Employee

How to factory reset C40

Hello,

can you access the unit via http:// or ssh and login as admin, or put differently, do you know the unit's IP address?

Then I think you should be able to execute the command :

xConfiguration SystemUnit IrSensor: On

Silver

How to factory reset C40

In addition to what Danny has mentioned, factory reset can be performed using any of the following procedure :

Factory reset the system

 Open the console/ssh session with codec and login as “root” user

 rm /mnt/base/active/config.db, this remove the current configuration file from Codec

 reboot

OR

 Open the console/ssh session with codec and login as “admin” user

xCommand SystemUnit FactoryReset Confirm: Yes

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar

Hello,

Hello,

I have three Cisco Telepresence codec's (C40) all user's passwords have expired. I can connect to it by IP and ssh, however all user accounts passwords are unknown. It appears my only solution is a factory reset... How would I go about doing this?

VIP Purple

Hello Michael -

Hello Michael -

Take a look at this discussion, password-recovery, depending on the software version your C40 is running, you may or may not have to perform a factory reset.

Thank you I will take a look

Thank you I will take a look current software version is 7.3.0 or higher.

13062
Views
0
Helpful
5
Replies