Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Intelligent Proximity - turning-off Endpoint control?

All is there a way to turn-off the endpoint control of Intelligent Proximity and only allow for Content Share?  Or limit the devices/users that can control the endpoint?

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

No, at least not at this

No, at least not at this stage, but it is a beta version after all.

Suggest you raise this issue in the Intelligent Proximity support forum: https://supportforums.cisco.com/community/12156681/cisco-proximity

/jens

Please rate replies and mark question(s) as "answered" if applicable.

Please rate replies and mark question(s) as "answered" if applicable.
4 REPLIES

No, at least not at this

No, at least not at this stage, but it is a beta version after all.

Suggest you raise this issue in the Intelligent Proximity support forum: https://supportforums.cisco.com/community/12156681/cisco-proximity

/jens

Please rate replies and mark question(s) as "answered" if applicable.

Please rate replies and mark question(s) as "answered" if applicable.

Trapa,Yes you can turn it off

Trapa,

Yes you can turn it off and on.

 

Yes there are limitations, see the table below:

 

 

API availability

TAC support

Max connections

 

TX

Not available

unsupported preview2

EX60, EX90

Experimental

No

5

C20, C40

Experimental

No

3

C60, C90

Experimental

No

5

MX200 G1, MX300 G1

Experimental

No

3

Full support by late 20141

SX10

Full

By release

8

SX20

Full

By release

7

SX80

Full

By release

30

MX200 G2, MX300 G2

Full

By release

7

MX700, MX800

Full

By release

30

 

Thanks,

Justin

Thank you,
Justin Ferello
Technical Support Specialist, ScanSource KBZ

"Yes you can turn it off and

"Yes you can turn it off and on."

How? I can't see any options to turn endpoint call control on/off anywhere? Only option I have is to turn Intelligent Proximity off/on, not the call control part.

/jens

Please rate replies and mark question(s) as "answered" if applicable.
VIP Purple

I see two questions in trapa

I see two questions in trapa's initial post, and I suppose Justin could have been replying to the second regarding the number of connections.

366
Views
0
Helpful
4
Replies
CreatePlease to create content