Actually I just started reading TP. We are using ASR1K as SBC.
I seen over there "interface SBC" something link below. I was searching config guidelines for CUBE SP and found the way to configure interface SBC but do not know meaning of it. I mean why do we need this interface , why we use so many ip addresses (primary and many secondary)
interface SBC3230 ip vrf forwarding XXXX
ip address x.x.x.242 255.255.255.248 secondary ip address x.x.x.243 255.255.255.248 secondary ip address x.x.x.244 255.255.255.248 secondary ip address x.x.x.245 255.255.255.248 secondary ip address x.x.x.246 255.255.255.248 secondary ip address x.x.x.241 255.255.255.248
"The interface sbc command is needed, whenever a VRF is being used. You must have a secondary IP address defined if the media IP address is going to be different than the signaling address. However, in this case the secondary IP address is automatically added when the media-address ipv4 command is used. It must not be manually entered."
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...