Our Cisco Telepresence server (8710) connected to VCS working with CTS-3010 endpoints (with presentation codec) registered with CUCM for presentation sharing during multipoint meeting.
We found that when sharing presentation from a CTS-3010 to other CTS-3010 via Cisco Telepresence Server 2.2 (Bridged) that is registered to VCS, only 5 fps is used. But, if point-to-point between two CTS, 30 fps is used.
I have read that calls through the Telepresence Server using the TIP protocol will have the Content/Presentation rate limited to 5fps. I couldn’t find this in any Cisco documentation but it was in some Polycom documentation discussing the Cisco Telepresence Server.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...