Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is compositing available when dialed into a TMS bridge

I have a C60 with compositing enabled.  When you do a point to point (via Jabber, or Endpoint) it works fine for the far end.  When you dial the C60 into a bridge on our 8510 blade it only shows one of the cameras, like the compositing is disabled.  Is there a setting I am missing on the MCU side?  Any help is appreciated.

Thanks, Tim

  • TelePresence
1 REPLY
VIP Green

Hi Tim.Yes, the compositor

Hi Tim.

Yes, the compositor does work when connected to a bridge.  We use it that way quite often to display two, or three inputs from our C60s to multiple parties, content recorders, etc.

There's nothing special that we needed to do on the MCU to make this work.

Wayne
--


Please remember to rate responses and to mark your question as answered if appropriate.

32
Views
0
Helpful
1
Replies