Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is MX700, MX800 and SX80 supported on VCS?

Hi,

I was wondering if the new MX700, MX800 and SX80 are supported on VCS.

The datasheets mention only CUCM, but doesnt mention VCS.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Guessing a lot of people have

Guessing a lot of people have the similar questions. We were confirmed by a  Cisco Support Engineer that SX and MX serials are supported by VCS (maybe need latest version, like V8.1.1), whereas DX serials are only supported by CUCM.

Hope that helps.

3 REPLIES
New Member

Guessing a lot of people have

Guessing a lot of people have the similar questions. We were confirmed by a  Cisco Support Engineer that SX and MX serials are supported by VCS (maybe need latest version, like V8.1.1), whereas DX serials are only supported by CUCM.

Hope that helps.

New Member

I've kept looking into this.

I've kept looking into this.

 

MX700 includes software version TC7.1.2 which is supported on VCS version 8.1 and avobe. 

 

There is no document that explicitely mentions that MX700 is supported by VCS... but, based on the software compatilibity... i think it is inferred that it does.

 

My comment has been confirmed by a Cisco virtual SE.

Yes, you can use these

Yes, you can use these systems with VCS, but be aware these systems are all single stack, so can only register with SIP or H.323, not both protocols as compared to the C-series where you can register the system with a VCS with both SIP and H.323 addresses.

Guess they're only mentioning CUCM in the datasheet as Cisco wants users to migrate to SIP and use CUCM for CAC instead of the VCS, and then use VCS for firewall traversal.

/jens

Please rate replies and mark question(s) as "answered" if applicable.

Please rate replies and mark question(s) as "answered" if applicable.
1383
Views
5
Helpful
3
Replies