ISDN PRI cable length on a ISDN gateway MSE 8321 or GWY3201
You should use a shielded 4-wire 120 Ohm twisted Pair Cable (often called PCM-Cable) instead of using common "Ethernet"-Cables with 100 Ohm impedance. A .
I recommend to use a cable with massive wires for the long distance (e.g. PCM 2 X 2 X 0.4) and a 120 Ohm Patch Cable with flex wires to connect the devices to a RJ45 jack (e.g. PCM 4x2xAWG26/7). Do not crimp massive wires directly on a RJ45 plug, because of potential reflections and bad connection. Always use a RJ45 Jack in beetween.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.