Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISR G2 to use for Video Gateway to ISDN

Hi all

We have the follow situation:


- MXP device which are connecte to the old PBX with ISDN

- old PBX which will be replaced with BE6K


Now questions is is it possible to use ths ISR G2 router to make ISDN Video Calls?


The Problem could be, I have a SIP trunk from the VCS to the CUCM and than if I make  a call from the MXP device via a Prefix , this prefix will be routed to the CUCM and than to the ISR.

I think ISR must be use H.323 and not MGCP or SIP.


is that possible?

has anyone use this ?


Any Inputevery appreciated.


Best Regards




Everyone's tags (1)
VIP Super Bronze

I was eagerly hoping someone

I was eagerly hoping someone else would have responded to this but since we're not that lucky, I'll share what I have bookmarked:

This falls into my "always wanted to figure it out but never had a project to justify spending the time on it" bucket. Please share the outcome of this, even if it's not a good one. Inquiring, if slightly lazy, minds want to know. :)

New Member

Hi Jonathan Thank you for the

Hi Jonathan


Thank you for the feedback.

At the moment the project is still under offering, i will see whats happen, I'm also interest to implement this.

I have got also an answer from the PDI Helpdesk, and the say is it possible to use the ISR.

now we will see.




CreatePlease to create content