07-15-2014 09:24 AM - edited 03-18-2019 03:11 AM
Hi all
We have the follow situation:
- VCS
- MXP device which are connecte to the old PBX with ISDN
- old PBX which will be replaced with BE6K
Now questions is is it possible to use ths ISR G2 router to make ISDN Video Calls?
The Problem could be, I have a SIP trunk from the VCS to the CUCM and than if I make a call from the MXP device via a Prefix , this prefix will be routed to the CUCM and than to the ISR.
I think ISR must be use H.323 and not MGCP or SIP.
is that possible?
has anyone use this ?
Any Inputevery appreciated.
Best Regards
Georg
07-26-2014 09:51 PM
I was eagerly hoping someone else would have responded to this but since we're not that lucky, I'll share what I have bookmarked:
http://www.cisco.com/c/en/us/td/docs/ios/12_4t/12_4t11/h320gw.html
This falls into my "always wanted to figure it out but never had a project to justify spending the time on it" bucket. Please share the outcome of this, even if it's not a good one. Inquiring, if slightly lazy, minds want to know. :)
08-04-2014 01:12 AM
Hi Jonathan
Thank you for the feedback.
At the moment the project is still under offering, i will see whats happen, I'm also interest to implement this.
I have got also an answer from the PDI Helpdesk, and the say is it possible to use the ISR.
now we will see.
Regards
Georg
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: