Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISSUE: Master&Slave MCU and Conductor, If Master fails..

Hi there,

I was wondering about the issue of failure of Master MCU.

There are VCS, TMS, Conductor(XC2.0) and 2MCU(5300) which has configured as Master and Slave(has been stacked).

If Master fails during conferencing of multiple participants with multway(over 5, less 10), What sort of problems are gonna occur?

especially wondering about:

1) Afterward, Can we make same conference with multiway using one another MCU which has used as a Slave?

2) Can Slave take the duty of Master?

3) Otherwise, What can we do for failover?

4) Stacked MCUs vs Cascaded MCUs with Conductor(XC2.0), How can we configure each?

Thank you.

best wishes,

Paul

224
Views
0
Helpful
0
Replies