Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Issue paring C20 with ISDN Link

Hi, Can anyone can help me on initial connectivity of C20 with ISDN Link? I have C20 codec with 1 LAN port which is connected to endpoint port of ISDN Link, the LAN port of ISDN Link is connected on internal LAN. I have configured the ISDN Link IP :XXX.XXX.XXX.251 and codec on XXX.252 both are same subnet.

Since there is single LAN port, How I can access the web interface of the codec to check and perform the pairing? If in case the codec is on older firmware not supporting auto pairing then how I can perform the manual pairing. Can only access the ISDN link through serial.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Issue paring C20 with ISDN Link

Hi

Can´t you just plug your PC into the internal LAN (same subnet as the ISDN Link and the codec) and access the webinterface of the codec: http://x.x.x.252 ?

What software versions are you running?

/Magnus

3 REPLIES
Cisco Employee

Issue paring C20 with ISDN Link

Hi

Can´t you just plug your PC into the internal LAN (same subnet as the ISDN Link and the codec) and access the webinterface of the codec: http://x.x.x.252 ?

What software versions are you running?

/Magnus

New Member

Issue paring C20 with ISDN Link

I connected the PC on Video VLAN on which the ISDN Link and Codec is but not able to get the web interface of the endpoint. I am only getting the ping response from the ISDN Link. The codec is running on lower version than 6.x.

Cisco Employee

Issue paring C20 with ISDN Link

516
Views
0
Helpful
3
Replies
CreatePlease to create content