I have registered for a Jabber free account and have my Movi client working well. I am trying to configure my Tandberg Profile 42 C20 to connect to the account but am having problems. My SIP Profile is configured as follows:
I am getting a "Failed" message for SIP when I look at the Diagnostics > System Configuration page. Do I need to fill out the proxy section? I could find directions on how to set up my software client but not for a Tandberg codec device.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.