I'm having some issues with Jabber video and bandwidth probing. Note that I'm just using WAN emulation in a lab at the moment, limiting to 800Kb/s.
I've got the TURN server etc configured on the TMSPE provisioning template and it appears to be working OK - when I go to Quick Setup in Jabber video, the bandwidth probe runs and returns results saying I will have low quality, which is exactly as I expected (this doesn't work if I change/remove the TURN server in the template). The problem I have is that this doesn't seem to adjust the outgoing bandwidth of a call - even if it's limited to 512Kb/s, it still makes a 1Mb/s call, gets a bunch of packet loss and eventually settles down at 512Kb/s. This takes a good 10 - 20 seconds per call.
I'm not sure if this is expected behaviour, but I'd much rather it make a call at whatever the limited bandwidth is, rather than attempting to call at a higher bandwidth first. Is this possible?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.