Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

License inquiry in the MSE8000

Dear all,

Based on Port matrix table of the  Administrator Guide

Mode          Licenses per port     Video ports

SD                          1                          80

HD                          2                          20

HD+                       4                           20

Full HD                   4                          15

Since our client would like to depoly "Full HD" in their network, anyone can confirm the maximum participant ( we guess is 15).

We did not need to buy full license on this case, the number of license(L-8420-2PL) should be 30  for this case?

Best Regards,

Ben Lai

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

License inquiry in the MSE8000

Yes, the numbers look ok, at least for a single 8510 blade.

Screen Shot 2014-01-23 at 12.55.46.png

The backdraw is that even if you would dial in with a low resolution device

it will still take one full hd port.

I would recomend you to look into the conductor and the telepresence server.

(Contact your Cisco Partner or Representative regards converting a 8510 to

a telepresence blade and condidtions for the Conductor).

That combination would give you a dynamic port allocation method, so depending

on the scenario you could get more users on it.

(from the TPS release notes:)

Screen Shot 2014-01-23 at 13.01.55.png

Please remember to rate helpful responses and identify helpful or correct answers.

Please remember to rate helpful responses and identify

2 REPLIES

License inquiry in the MSE8000

Yes, the numbers look ok, at least for a single 8510 blade.

Screen Shot 2014-01-23 at 12.55.46.png

The backdraw is that even if you would dial in with a low resolution device

it will still take one full hd port.

I would recomend you to look into the conductor and the telepresence server.

(Contact your Cisco Partner or Representative regards converting a 8510 to

a telepresence blade and condidtions for the Conductor).

That combination would give you a dynamic port allocation method, so depending

on the scenario you could get more users on it.

(from the TPS release notes:)

Screen Shot 2014-01-23 at 13.01.55.png

Please remember to rate helpful responses and identify helpful or correct answers.

Please remember to rate helpful responses and identify

Community Member

License inquiry in the MSE8000

Dear Martin,

Thanks for your advise.

It is right there is a backdraw for such deployment.

We have a quick review on the dynamic port allocation, it seem much more efficient in MCU resource arrangement.

Best Regards,

Ben

268
Views
0
Helpful
2
Replies
CreatePlease to create content