Is it possible to set default audio gain for audio partipicants within an combined Video and Audio meeting?
Gain can be adjusted after a partipicant is active but I dont see a way to set default level.
When we have combined calls (Tandburg video endpoints- Callmanager SCCP 7965 telephones via sip trunk audio dial in) the audio partipicants are louder than video partipicants, we're looking have all participants at an equal volume level.
Is it possible to request some sort of normalization feature on the MCU? I got the same question from a client that is experiencing the exact same issue but with Movi clients and codecs.
All of their Movi Clients use Headsets and the users are not savvy enough to change the mic in volume in winows. I know that the upcoming 4.3 Movi Client has better control of the audio, but it´s never the less going to be hard for the user to manually match the volume to that of the codecs.
I'll second that one - we've just commissioned our very first 4520 and the audio issue became quite noticeable the very first time we used it "in anger", with an EX90, MXP and 2 Movi clients in the call (heh - two of participants were Cisco guys ), in this particular case it was the EX90 which was "too loud" so to speak.
Since the majority of our Movi users also use headsets, I can see this quickly becoming an annoyance for lot of people, to say the least.
Please rate replies and mark question(s) as "answered" if applicable.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...