Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Multisite Feature Cisco C90, MX300 and SX20

Hello Everyone,

Anybody has information about how install Licenses Multisite L-C90-MS, LIC-MX300-MS and LIC-SX20-MS?  These ones are directly installed in the codec? how is the procedure?

Thanks a lot!!

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Mario, These are option keys

Mario,

 

These are option keys that you will add directly to the codec. Just go to Maintenance>Upgrade and paste the option key into the option key field. This usually requires a reboot when done.

 

Adam

3 REPLIES
Cisco Employee

Mario, These are option keys

Mario,

 

These are option keys that you will add directly to the codec. Just go to Maintenance>Upgrade and paste the option key into the option key field. This usually requires a reboot when done.

 

Adam

VIP Green

It depends on how you receive

It depends on how you receive your licence key.

Usually, they come as a PAK - you need to register this on the Cisco Licencing Portal and assign the PAK to a specific endpoint.  From this, you will then get the Licence Key (1M003-1-XXXXXXXX).

This Licence Key you can enter in to your endpoint - On the Web Interface, Go to Maintenance > Software Upgrade and put the key in the "Option Key" field and click the "Add" button.

You can also do it from the Command Line Interface with the xcommand SystemUnit OptionKey Add Key: command.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
VIP Purple

Here is a document that shows

Here is a document that shows how to add the keys into the codec.

entering-licensing-mxp-and-tc-series-tandberg-endpointspdf

393
Views
0
Helpful
3
Replies
CreatePlease login to create content