Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Multiway URI and TMSPE

Looking through the Multiway deployment guide, it tells you to use meet.{username}@<SIP-domain> in the Multiway URI configuration template in TMSPE.

Are there any variables available other than {username} (prefferably something like mobile_phone or address_pattern) that you can set as the multiway URI in a TMSPE configuration template?

4 REPLIES
VIP Purple

I'm not able to test this

I'm not able to test this until I get to work tomorrow, but I use the {display_name} and {username} variables within templates to automatically set an endpoint's display name and multiway URI based on the user's account in TMSPE.  So I'd assume using other TMSPE variables should work as well.

Thanks Patrick, I've tried it

Thanks Patrick, I've now tried it and office phone does indeed work.  I was hoping there was some documentation or something listing everything I could use, but office phone sorts out my problem for the time being anyway.

VIP Purple

Good to hear it works.I'd

Good to hear it works.

I'd assume you could use any of the variables noted in the TMSPE Deployment Guide, on pg 34.  Might just have to try the specific one you want and see if works.

Ah, didn't think of that, I

Ah, didn't think of that, I was reading the multiway and Jabber guides, but not the TMSPE one :)

73
Views
10
Helpful
4
Replies