Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

MX200 Console Access

For MX200, is the port marked "For  maintenance only" the console port? Since the package didn't came with  any console cable, I used the usual console access with the 38400 baud,  but not successful.

I changed the baud to 9600 via SSH, the same!  The "xoncifuration" shown the SerialPort Mode is on. Any ideas what the  problem could be?

3 REPLIES
Silver

MX200 Console Access

Hi Jack,

Yes, the maintenance port is the one used. Are you using an RJ45 to COM cable ? I am not very sure about the specifications but the serial cable is a special one. It should be similar to the one used by Ex90. Please refer to the following document :

https://supportforums.cisco.com/docs/DOC-24305

Once you have done that. You might use COM to USB converter as the laptops these days do not have a COM port. If that's the case, make sure that you install the driver for the COM to USB converter otherwise it will not work.

Please let me know if you have any other query.

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar

MX200 Console Access

I think I would be more happy if a proper serial port with standard rs232 levels would be found on the endpoints, ....

Please remember to rate helpful responses and identify

Cisco Employee

MX200 Console Access

RJ45-DSub9pin serial adapter mention in https://supportforums.cisco.com/docs/DOC-24305 works for EX90, EX60, MX200 and MX300.

All C-series default console baud rate is 38400.

720
Views
0
Helpful
3
Replies
CreatePlease to create content